Driwall™ LathNet®
Driwall™ LathNet combines galvanized metal lath with a polyethylene drainage mesh, providing a two-in-one solution that simplifies the installation process for stucco and thin-stone veneer systems.
Driwall™ LathNet combines galvanized metal lath with a polyethylene drainage mesh, providing a two-in-one solution that simplifies the installation process for stucco and thin-stone veneer systems.
KeeneSeal 100 is a one component, fast grab, multipurpose silyl-terminated polyether (hybrid) elastomeric sealant.
HouseNet® keeps residential masonry cavity walls dry by suspending mortar droppings above flashings and weeps, ensuring clear drainage paths and airflow. Its 90% open mesh promotes moisture escape and ventilation, preventing mold, rot, and costly water damage over time.
WallDefender suspends mortar droppings above the flashing and weeps so they stay clear and unobstructed.
The patented TotalFlash Cavity Wall Drainage Solution Panel is a complete, factory-assembled masonry cavity wall flashing system that cuts labor costs and provides better performance than standard through wall flashing. It combines a flashing membrane with a mortar dropping collection drainage mat, weep tabs, drip edge and termination bar into a single, easy-to-install panel.
14″ high inside/outside preformed corner boots for masonry cavity walls that extend above the standard flashing height and make it easy to create a consistently high quality corner every time.
WeepVents™ are a polyester non-woven mesh vent that are inserted into open head joints to allow moisture to exit the cavity and to help prevent insects.
CellVent for masonry cavity walls helps ensure that moisture can migrate out and air can circulate into the cavity, and that insects can’t enter the cavity through the weep holes.
Mortar Net Solutions’ stainless steel inside & outside corners, and universal end dams help protect from moisture penetration at corners and end of runs in flashing installations. They are manufactured from 26-gauge Type 304 stainless steel for excellent durability and are soldered at joints to ensure leak-proof seams.
Now offering type 304 stainless steel and aluminum termination bar in 8′ lengths. They are also available in the T1 and T2 profile to fit your project needs. We always recommend termination bar to mechanically fasten the flashing.